Account login:
Your cart:
0 item(s) in your cart
Total: £0.00

Hawke

Hawke 30 MOA Adjustable Scope Mount Rings 30mm High for 9-11mm Dovetail 22140

£31.95
You will earn 31 loyalty points with this purchase
Hawke +/-30 MOA Adjustable Scope Mount Rings for 30mm tube scopes - High Profile to fit 3/8" / 9-11mm Dovetail bases - Hawke product number 22140
 

Pair - 2 rings supplied
 

  • Adjustable elevation - compensation of +/- 30 MOA
  • High - to accommodate larger objective scopes
  • Double torx screws to hold your scope firmly in place
  • Fitted with a recoil stop pin
  • Reversible dove tail clamp that fits 9-11mm and 3/8 inch
  • Internal cushion tape prevents marking and damage
  • High grade aluminium anodized in matte black


30mm Tube -

  • Ring is 30mm diameter.
  • To suit scopes with 30mm diameter tubes.

High Profile Height -

Overall Height 54mm

  • 20mm base to bottom of ring "Saddle"
  • In practice this means in most cases scopes upto approx. 60mm lens when on a flat base.
  • However if base is raised or end of scope will be over barrel with more space then larger lens scopes may be used.
  • This is down to the user to determine we can only give broad guidelines.
  • See scope clearance guide at bottom of page.
 

Tech Spec

  • Configuration: 2 Piece (Adjustable)
  • Ring Size (Diameter): 30mm
  • Height: High
  • Rail: 9-11mm
  • Fixings (Rail & Top Cap): Double Hex Screw
  • Internal Cushion: YES
  • Retractable 'Recoil Stop' Pin: YES
  • Height: 54mm / 2.1″
  • Weight: 114g / 4oz
Precision engineered from high grade aluminium
with rounded edges prevent scope damage.

 

Calculating scope to rifle body clearance

The way you calculate the clearance is by halving the overall OUTSIDE diameter of your rifle scopes objective lens and then deducting half the rifle scopes body tube diameter.

For scopes with a 1" diameter body tube diameter this would mean deducting 12.7mm and 15mm for scopes with a 30mm diameter body tube.

Note we say OUTSIDE diameter - this means NOT the lens diameter, you need to measure the whole outer casing diameter.

The result gives you the minimum "saddle" dimension required - the measure from base of mount to bottom of the ring.

The amount the saddle dimension is greater than the figure you have calculated is the amount of clearance your scopes objective will be clear of your rifles body.  The saddle on these mounts is 6.35mm

Example -

  1. A 56mm objective lens scope is measured and found to have an outer case measurement of 66mm.
  2. 66 divided by 2 = 33
  3. 30mm scope so deduct 15mm = 18mm
  4. So the mount must have a measure (bottom of mount to bottom of the ring) greater than 18mm or else it will ground out on the rifle body.

Calculating your rifle scopes clearance in this way does assume the base is basic flat, not raised above or below your rifles barrel. Note some rifles with high or adjustable cheek pieces may require higher scope mounts or risers so that your eye is in line with the rifle scope and your head is kept in an upright comfortable position.

Own this product? Write a review.
Brand Hawke
Code NW1654
Weight 0.2kg
EAN 5054492221400
MPN 22140