Hawke Match Mounts

Name: Hawke Match 1 inch 25mm High Weaver Base Scope Mount Rings - 22114
Brand: Hawke
SKU: NW949
Price: 21.95 GBP
Availability: InStock

Hawke Match 1 inch 25mm High Weaver Base Scope Mount Rings - 22114

£21.95

1" (25mm) ring for weaver/picatinny base. Suit 40-56mm scopes.

You will earn 21 loyalty points with this purchase

DetailsReviewsSpecifications

Hawke Match 1 inch 25mm High Weaver Base Scope Mount Rings - 22114

For 1" (25mm) scope tubes for fitting on 20mm weaver/picatinny base.

Match Mounts feature a stylish ribbed top cap that is also fastened by double screws on each side. During manufacture all the sharp edges are rounded to prevent the accidental pinching of the riflescope tube.

A stylish scope mounting solution. Enhances the look of your favourite rifle and scope.

Key Features:

For 1 inch - 25mm Tube
For fitting on a 20mm weaver/picatinny base rail.
Double hex screws on top for super grip
Internal cushion tape (prevents scope damage)
“Quick Peep” sight window for viewing iron sights
High profile
- 20mm total saddle = max outer objective case diameter of 65mm
- Typically this means they will suit upto 50mm lens scopes - depending on outer case width and lens caps in use etc
- But check outer casing diameter if the scope is 66mm you will need to use a riser.

Additional Features:

Rounded edges prevent scope damage
Precision engineered from high grade aluminium
Anodized Matt Black

The modern spring powered air rifle can deliver high levels of muzzle velocity in countries where the law permits. High powered air rifles deliver a punishing recoil which can shake a riflescope out of zero if the scope mounts are not designed to withstand that recoil.

Spring airguns create double recoil requiring a well designed mounting system. Hawke Match Mounts feature cushion tape to prevent damage to the riflescope tube.

The mounts feature a stylish ribbed top cap that is also fastened by double screws on each side. During manufacture all the sharp edges are rounded to prevent the accidental pinching of the riflescope tube.

A stylish scope mounting solution. Enhances the look of your favourite rifle and scope.

Calculating scope to rifle body clearance

The way you calculate the clearance is by halving the overall OUTSIDE diameter of your rifle scopes objective lens and then deducting half the rifle scopes body tube diameter.

For scopes with a 1" diameter body tube diameter this would mean deducting 12.7mm and 15mm for scopes with a 30mm diameter body tube.

Note we say OUTSIDE diameter - this means NOT the lens diameter, you need to measure the whole outer casing diameter.

The result gives you the minimum "saddle" dimension required - the measure from base of mount to bottom of the ring - the 'C' dimension that is shown above.

The amount the saddle dimension is greater than the figure you have calculated is the amount of clearance your scopes objective will be clear of your rifles body. The saddle on these mounts is -

Example -

A Nikko Nighteater 1" 4-16x44 scope has an outer case measurement of 51mm.
51 divided by 2 = 25.5.
1" scope so deduct 12.7mm = 12.8mm
So the mount must have a saddle measure (base of mount to bottom of the ring) greater than 12.8mm or else it will ground out on the rifle body.

Calculating your rifle scopes clearance in this way does assume your dovetail or base is not raised above or below your rifles barrel. Note some rifles with high or adjustable cheek pieces may require higher scope mounts or risers so that your eye is in line with the rifle scope and your head is kept in an upright comfortable position.