Every pair of Element Accu-Lite rings begin their life as a single block of 7075-T6 Aluminium, which has a strength-to-weight ratio superior to almost any other alloy.
This block is CNC machined to the tightest tolerances to ensure a smooth and precise mating surface between the riflescope body tube & base.
Add to that a Stainless Steel crossbolt, base clamp & nut, and you have one of the most precisely built, reliable ring sets on the market.
A good ring set is critically important, as it is the only point of connection between your rifle and riflescope.
We’re confident that the Accu-Lite will provide you a lifetime of reliable service, giving you peace of mind in even the harshest shooting environments.
- Precision CNC Machined from aircraft-grade 7075-T6 Aluminum & Stainless Steel
- Built to handle high torque specs without failing
- Universal Base Nut can be used with Metric & Imperial wrenches
- Fits both Weaver and Picatinny rails
- Rounded finish prevents snagging on bags, vegetation & obstacles
- Height - High profile - 29mm (1.14") base to ring centre = 14mm base to ring bottom
- Weight (pair) 137g / 4.8oz
- Material: 7075-T6 Aluminum & Stainless Steel
- Mounts to - Picatinny/Weaver
- Tools required - 13mm OR 1/2” SOCKET/SPANNER, T15 TORX
Torque - take care as over-torquing rings can lead to temporary or permanent damage of the riflescope body tube and internals.
Estimating scope to rifle body clearance
- Rings - Recommended - Refer to rifle scope torque specs. But no more than maximum 25 IN-LBS (2.8NM)
- Base - Recommended 50 IN-LBS (5.6NM) - Maximum 68 IN-LBS (7.7NM)
The way you calculate the clearance is by halving the overall OUTSIDE diameter of your rifle scopes objective lens and then deducting half the rifle scopes body tube diameter.
For scopes with a 30mm diameter body tube diameter this means deducting 15mm
Note we say OUTSIDE diameter - this means NOT the lens diameter, you need to measure the whole outer casing diameter.
The result gives you the minimum "saddle" dimension - the measure from base of mount to bottom of the ring.
The amount the saddle dimension is greater than the figure you have calculated is the amount of clearance your scopes objective will be clear of your rifles body.
- An example 30mm tube scope has an outer case measurement of 54mm.
- 54 divided by 2 = 27
- 30m scope so deduct 15mm = 12mm
- Therefore the mount must have a saddle measure (base of mount to bottom of the ring) greater than 12mm or else it will ground out on the rifle body.
Calculating your rifle scopes clearance in this way does assume the base is not raised above or below your rifles body or barrel. Many weaver/picatinny bases are raised so take this into account when estimating clearance.
No reviews have been left for this product, be the first to leave a review