Is it in stock? If you can add it to cart, yes, in stock. Out of stock cannot be ordered
Free UK Shipping on all orders over £50
Flexible Payment options with Klarna & LayBuy
Need help? Fast Reply Email or call us: 0843 5328462

Hawke Tactical Mounts

Hawke Tactical Mounts 30mm 2pc 9-11mm Dovetail MEDIUM Scope Mount Rings 24106

Hawke Tactical Mounts 30mm 2pc 9-11mm Dovetail MEDIUM Scope Mount Rings 24106

£39.95 £33.29 (ex. VAT)
Stock Status: In Stock
Medium - 11mm base to ring bottom. For 30mm tube scopes on 9-11mm dovetail. Max scope outer case diameter 51mm
You Will Earn 39 points with this purchase

Make 6 weekly payments of £6.66.

Interest free. Learn More

Super strong and robust mounts

Triple torx screws to hold your scope firmly in place
Recoil Pin Stop
Rail 9-11mm
Internal cushion tape prevents marking and damage
High grade aluminium anodized in matte black

Configuration: 2 Piece
Ring Size (Diameter): 30mm
Height: Medium (low medium) - 11mm base to ring bottom
Rail: 9-11mm dovetail
Fixings (Top Cap): Triple Torx Screw
Fixings (Rail): Double Hex Screw
Internal Cushion: YES
Retractable 'Recoil Stop' Pin: YES
Height: 46mm / 1.8″
Weight: 124g / 4.4oz

Fitting guidelines and clearance considerations

These mounts are for 9-11mm dovetail rails as typically found on air rifles and rimfire.

They are for 30mm scope tubes

They are an "on the low side" medium profile with 11mm measured from base of mount to base of ring (Saddle) - This is a critical dimension when calculating clearance over the rifle body.

Calculating scope to rifle body clearance

The way you calculate the clearance is by halving the overall OUTSIDE diameter of your rifle scopes objective lens and then deducting half the rifle scopes body tube diameter.

For scopes with a 30mm diameter body tube diameter this means deducting 15mm.

Note we say OUTSIDE diameter - this means NOT the lens diameter, you need to measure the whole outer casing diameter.

The result gives you the minimum "saddle" dimension required - the measure from base of mount to bottom of the ring.

The amount the saddle dimension is greater than the figure you have calculated is the amount of clearance your scopes objective will be clear of your rifles body.  The saddle on these mounts is 11mm

Example -

  1. A 50mm objective lens scope is measured and found to have an outer case measurement of 57mm.
  2. 57 divided by 2 = 28.5.
  3. 30mm scope so deduct 15 = 13.5
  4. So the mount must have a saddle measure (base of mount to bottom of the ring) greater than 13.5mm or else it will ground out on the rifle body.
  5. So with 11mm these are too short by 2.5mm unless the base is raised in some way. Go up to High profile if the base is flat

Calculating your rifle scopes clearance in this way does assume your dovetail or base is not raised above or below your rifles barrel. Note some rifles with high or adjustable cheek pieces may require higher scope mounts or risers so that your eye is in line with the rifle scope and your head is kept in an upright comfortable position.

  • EAN:
  • MPN:
    24 106
  • Height:
    11mm base to ring bottom
  • Brand:
  • Product Code:
  • Weight:
Not yet reviewed
Write an online review and share your thoughts with other shoppers!
Be the first to review this product