Hawke Reach Forward Mounts
Hawke 1 inch High Profile Weaver Base Base 1" Reach Forward Scope Mount Rings 22124
Hawke 1 inch High Profile Weaver/Picatinny Base Base 1" Reach Forward Scope Mount Rings
Anodised in matte black with double screw ring clamp design and cushion tape.
- Double Hex screws
- Internal cushion tape (prevents scope damage)
- 1 inch - 25mm Scope Tube
- 1" Reach Forward configuration
- For weaver 20mm base
- Suit upto 56mm lens scopes (50mm if flip up caps fitted)
Summary of Features:
Ring Size (Diameter): 1" / 25.4mm
Fixings (Rail & Top Cap): Double Hex Screw
Internal Cushion: Yes
Retractable 'Recoil Stop' Pin: No
Height: 50mm / 1.9"
Weight: 71g / 2.5oz
Precision engineered from high grade aluminium with rounded edges prevent scope damage.
Calculating scope to rifle body clearance
The way you calculate the clearance is by halving the overall OUTSIDE diameter of your rifle scopes objective lens and then deducting half the rifle scopes body tube diameter.
For scopes with a 1" diameter body tube diameter this would mean deducting 12.7mm and 15mm for scopes with a 30mm diameter body tube.
Note we say OUTSIDE diameter - this means NOT the lens diameter, you need to measure the whole outer casing diameter.
The result gives you the minimum "saddle" dimension - the measure from base of mount to bottom of the ring - the 15mm dimension that is shown above.
The amount the saddle dimension is greater than the figure you have calculated is the amount of clearance your scopes objective will be clear of your rifles body.
- An example1" 4-16x44 scope has an outer case measurement of 51mm.
- 51 divided by 2 = 25.5.
- 1" scope so deduct 12.7mm = 12.8mm
- So the mount must have a saddle measure (base of mount to bottom of the ring) greater than 12.8mm or else it will ground out on the rifle body.
Calculating your rifle scopes clearance in this way does assume your dovetail or base is not raised above or below your rifles barrel. Note some rifles with high or adjustable cheek pieces may require higher scope mounts or risers so that your eye is in line with the rifle scope and your head is kept in an upright comfortable position.