MOVING SALE - 10% off orders over £150 auto applied at checkout. Over £150 also gets FREE UK delivery. Website platform move early first week April (new site Will be loads better) but current Loyalty points will stop working after the move. So if you have them use them! Will be a new points program on new site. We "may" be able to transfer current points on request. Looking for ideas? See the Top Picks section >>>

Flexible Payment for that big treat - Split it into 3 parts with Paypal Pay in 3

Need Help? Email HERE for a fast email response

Hawke Tactical Mounts

Hawke Tactical Mounts 30mm 2pc 9-11mm Dovetail EXTRA-HIGH Scope Mount Rings 24108

Hawke Tactical Mounts 30mm 2pc 9-11mm Dovetail EXTRA-HIGH Scope Mount Rings 24108

Stock Status: In Stock
Extra High - 23mm base to ring bottom. For 30mm tube scopes on 9-11mm dovetail. Max scope outer case diameter 75mm
You Will Earn 40 points with this purchase

Super strong and robust mounts

Triple torx screws to hold your scope firmly in place
Recoil Pin Stop
Rail 9-11mm
Internal cushion tape prevents marking and damage
High grade aluminium anodized in matte black

Configuration: 2 Piece
Ring Size (Diameter): 30mm
Height: Extra High - 23mm base to ring bottom
Rail: 9-11mm dovetail
Fixings (Top Cap): Triple Torx Screw
Fixings (Rail): Double Hex Screw
Internal Cushion: YES
Retractable 'Recoil Stop' Pin: YES
Height: 58mm / 2.3″
Weight: 138g / 4.9oz

Fitting guidelines and clearance considerations

These mounts are for 9-11mm dovetail rails as typically found on air rifles and rimfire.

They are for 30mm scope tubes

They are "extra high" profile with 23mm measured from base of mount to base of ring (Saddle) - This is a critical dimension when calculating clearance over the rifle body.

Calculating scope to rifle body clearance

The way you calculate the clearance is by halving the overall OUTSIDE diameter of your rifle scopes objective lens case and then deducting half the rifle scopes body tube diameter.

For scopes with a 30mm diameter body tube diameter this means deducting 15mm.

Note we say OUTSIDE diameter - this means NOT the lens diameter, you need to measure the whole outer casing diameter.

The result gives you the minimum "saddle" dimension required - the measure from base of mount to bottom of the ring.

The amount the saddle dimension is greater than the figure you have calculated is the amount of clearance your scopes objective will be clear of your rifles body.  The saddle on these mounts is 23mm

Example -

  1. A 50mm AO objective lens scope is measured and found to have an outer case measurement of 64
  2. 64 divided by 2 = 32
  3. 30mm scope so deduct 15 = 17
  4. So the mount must have a saddle measure (base of mount to bottom of the ring) greater than 17mm or else it will ground out on the rifle body.
  5. So with 23mm there will be 6mm clearance on a flat base..

Calculating your rifle scopes clearance in this way does assume your dovetail or base is not raised above or below your rifles barrel. Note some rifles with high or adjustable cheek pieces may require higher scope mounts or risers so that your eye is in line with the rifle scope and your head is kept in an upright comfortable position.

  • MPN:
    24 108
  • Height:
    23mm base to ring bottom
  • Brand:
  • Product Code:
  • Weight:
product review overlay image

Customer reviews

No reviews left yet
Write A Review

No reviews have been left for this product, be the first to leave a review